OE Replacement Steering Kit Upgrade | 2007-2021 Tundra

You are no longer limited by the lack of strength or functionality in your OE outer tie rods. We have designed a steering kit upgrade that will not only eliminate the bump steer most feel after lifting your Tundra but will allow the front suspension to fully cycle without fluctuation in the toe. All of this results in uneven tire wear.

Key Features:                      

Improved strength and increase travel at the steering by up to 30%.

Greatly reduce bumpsteer and uneven tire wear.

Clean bolt on with no modification.

Rebuildable Joints.

7075 Billet W/Hard Anodized Finish, 7/8″ Forged 4130 chromoly rod end, PTFE inserts, 303 stainless misalignment spacers, rubber grease boots and hardened hardware. Coachbuilder Steering Kits available for all Tundra applications.

** Installs in 45-60 Mins

Please Note: When using OE Spindles and installing joint on under side of steering knuckle. you MUST be running at least a 17" wheel with +25mm or less offset. 18″ wheel with a +35 mm offset or less, 20″ or larger wheels work with any offset.

Please Note: When using Aftermarket Spindles with applications installing joint on the top side of steering knuckle you MUST being running 18" wheels with 0mm offset or less. 20" Wheels require +25mm offset or less.

Compatible Applications :

OE Replacement Kit is compatible with:

Factory Original Spindles.

CST Spindles.

Maxtrac Spindles.

ReadyLift 4" / 6" / 8" lifts

Rough Country 6"

Alignment specs to use after installing:

Camber +.2 Degrees Per Side.

Caster +2.2 - +2.5 Degrees Per Side.

Toe +.07 - +.10 Degrees Per Side, Not to Exceed +.20 Combine.